1. Home
  2. SC6.1 Street Eliminator Build

Setup notes –

In order to setup your SC6.1 to make it a Street Eliminator machine, it’s necessary to make changes. First, check our build located on the JConcepts Garage showing the detail and parts used throughout. The JConcepts racer has been built using B6 front and rear arms as well as turnbuckles which bolt directly to the SC6.1. It’s necessary to run a B6 buggy front shock tower and shocks on the front-end while the rear should also use stadium truck front shocks and the JConcepts #2419 rear tower.

Front suspension:

AE #61673 – B6 gull wing front arms

JC #2405 – JConcepts B6 gull wing front tower

JC #2580 – B6.1 Fin Titanium turnbuckle kit (complete vehicle set)

AE #91480 – 23mm shock bodies

AE #91615 – 21mm shock shaft

AE #91626 – 1.6 piston

AE #91820 – Long shock end

AE #91330 – blue front springs

JC #2295 – 1, 3.3mm limiter, 1, 6.4mm limiter (inner limiters)

JC #2295 – 1, 3.3mm limiter (outside up-travel limiter)

AE #2453 – 40wt shock oil

Rear suspension:

AE #91777 – B6.1 rear suspension arms

AE #91434 – 67mm rear CVA bone

JC #2419 – JConcepts drag racing rear shock tower

AE #91481 – 27.5mm shock bodies

AE #91615 – 21mm shock shaft

AE #91627 – 1.7 piston

AE #91820 – short shock end

AE #91331 – yellow front springs

JC #2295 – 1, 3.3mm limiter, 1, 6.4mm limiter (inner limiters)

JC #2295 – 1, 3.3mm limiter (outside up-travel limiter)

AE #2453 – 40wt shock oil